Emc Measures; Data Protection - Fronius 1202 Bedienungsanleitung

Safety measures
in normal opera-
tion
EMC device clas-
sifications

EMC measures

Data protection

20
- Chargers with PE conductors must only be operated on a mains supply with
a PE conductor and a socket with an earth contact. If the charger is operated
on a mains supply without a PE conductor or in a socket without an earth
contact, this will be deemed gross negligence. The manufacturer shall not
be held liable for any damage arising from such usage.
- Only operate the charger in accordance with the degree of protection shown
on the rating plate.
- Under no circumstances operate the charger if there is any evidence of dam-
age.
- Ensure that the cooling air can enter and exit unhindered through the air
ducts on the charger.
- Arrange for the mains and charger supply to be checked regularly by a qual-
ified electrician to ensure the PE conductor is functioning properly.
- Any safety devices and parts that are not functioning properly or are in im-
perfect condition must be repaired by a qualified technician before switching
on the charger.
- Never bypass or disable protection devices.
- After installation, a freely accessible mains plug is required.
Devices with emission class A:
- are only designed for use in an industrial setting
- can cause conducted and emitted interference in other areas.
Devices with emission class B:
- satisfy the emissions criteria for residential and industrial areas.
This also applies to residential areas in which power is supplied
from the public low-voltage grid.
EMC device classification according to the rating plate or the techni-
cal data.
In certain cases, even though a device complies with the standard limit values
for emissions, it may affect the application area for which it was designed (e.g.
when there is sensitive equipment at the same location, or if the site where the
device is installed is close to either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate
action to rectify the situation.
The user is responsible for the safekeeping of any changes made to the fac-
tory settings. The manufacturer accepts no liability for any deleted personal
settings.