Safety Measures In Normal Operation; Emc Device Classifications; Emc Measures; Maintenance - Fronius Acctiva Smart 25 A Bedienungsanleitung

Safety measures Chargers with a ground conductor must only be operated on a mains supply with a
in normal opera- ground conductor and a socket with a ground conductor contact. If the charger is opera-
tion ted on a mains supply without a ground conductor or in a socket without a ground con-
ductor contact, this will be deemed gross negligence. The manufacturer shall not be held
liable for any damage arising from such usage.
Only operate the charger in accordance with the degree of protection shown on the
rating plate.
Under no circumstances operate the charger if there is any evidence of damage.
Arrange for the mains cable to be checked regularly by a qualified electrician to ensure
the ground conductor is functioning properly.
Any safety devices and parts that are not functioning properly or are in imperfect condi-
tion must be repaired by a qualified technician before switching on the charger.
Never bypass or disable protection devices.
After installation, an accessible mains plug is required.
EMC Device Clas- Devices in emission class A:
sifications -
-
Devices in emission class B:
-
EMC device classification as per the rating plate or technical data.

EMC measures

In certain cases, even though a device complies with the standard limit values for emissi-
ons, it may affect the application area for which it was designed (e.g. when there is sen-
sitive equipment at the same location, or if the site where the device is installed is close
to either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate action to
rectify the situation.

Maintenance

Before switching on, always check the mains plug and cable as well as charger leads
and charging terminals for any signs of damage.
If the surface of the device housing is dirty, clean with a soft cloth and solvent-free clea-
ning agent only.
Warranty and lia- The warranty period for the charger is 2 years from the date of invoice.
bility However, the manufacturer will not accept any liability if the damage was caused by one
or more of the following:
-
-
-
-
-
-
50
Are only designed for use in industrial settings
Can cause line-bound and radiated interference in other areas
Satisfy the emissions criteria for residential and industrial areas. This is also true for
residential areas in which the energy is supplied from the public low-voltage mains.
Use of the charger "not in accordance with the intended purpose"
Improper installation and operation.
Operating the charger with faulty protection devices.
Non-compliance with the operating instructions.
Unauthorised modifications to the charger.
Catastrophes caused by the activities of third parties and force majeure.