Assembling; Ceiling Mounting; Mounting On A Pavilion - Blumfeldt Heatbell Smart Ceiling Bedienungsanleitung

EN
16

ASSEMBLING

• When unpacking the heater, check that the scope of delivery is complete
and ensure that no device components remain in the packaging and that it
is free of packaging materials.
• Do not insert the power plug of the device into the socket until the device
has been completely assembled.
• Do not connect the heater to the power supply under any circumstances if
the components or the power cord are damaged.
• In case of doubt, contact the manufacturer, customer service or a similarly
qualified person.

CEILING MOUNTING

1. Drill a 10 mm diameter hole in the ceiling.
2. Press the self-adhesive hook into the drilled hole.
3. Tighten the hook properly.
4. Hang the heater on the hook with a chain. Make sure that the distance
between the ceiling and the heater is at least 3 cm. The minimum distance
between the floor and the heater is 1.80 meters.
5. Lay the power cable along the chain to the socket. The mains cable must
be fixed to the chain with a strap. Make sure that the power cable does not
touch the top 3 links of the chain. The power cord must never come into
contact with the heater. The heater must never be hung up on the power
cable.
Note: During use, the heater must be facing down.
After fixing to a wall or ceiling direction of radiation cannot be changed
without the aid of a tool.

MOUNTING ON A PAVILION

Make sure the tent frame is strong enough to support the weight of the heater.
1. Connect the chain to the heater.
2. Wrap the chain around the tent frame several times and attach the second
end, as well as the first, to the heater as well. Make sure that the minimum
distance between the suspension point and the heater is 30 cm. The
minimum distance between the floor and the heater is 1.80 meters.
3. Make sure that the heater is hanging securely.