Installation - IKEA LAGAN HGC3K AA-480616-1 Bedienungsanleitung

ENGLISH

Installation

Manufacturer is not responsible for any injury
to persons and pets or damage to property
caused by failure to comply following require-
ments.
Caution! To proceed with the installation
refer to the assembly instructions.
Warning! Installation process must follow
the laws, ordinances, directives and
standards (electrical safety rules and
regulations, proper recycling in accordance
with the regulations, etc.) in force in the country
of use!
Warning! The appliance must be
earthed!
Warning! Risk of injury from electrical
current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of volt-
age.
• Loose and inappropriate plug and socket
connections can make the terminal over-
heat.
• Have the clamping connections correctly in-
stalled.
• Use strain relief clamp on cable.
• Follow the connection diagram (it is located
on the underneath surface of the casting of
the hob).
Important! You must observe the minimum
distances to other appliances and furniture
cabinets or other units according to Assembly
Instruction.
If there is no oven beneath the hob insert a di-
viding panel at a minimum distance of 20 mm
from the bottom of the hob.
All manuals and user guides at all-guides.com
Do not use silicon sealant between the appli-
ance and the worktop. Avoid installing the ap-
pliance next to doors and under windows as
hot cookware may be knocked off the rings
when doors and windows are opened.
Only an authorized service engineer can in-
stall, connect or repair this appliance. Use only
original spare parts.
Electrical connection
Before connecting, check that the nominal volt-
age of the appliance stated on the rating
plate, corresponds to the available supply
voltage. Also, check the power rating of the
appliance and ensure that the wire is suitably
sized to suit the appliance power rating (refer
to the Technical data chapter).
The rating plate is located on the lower casing
of the hob.
The appliance is not provided with mains ca-
ble. Buy the right one from specialized dealer.
Single-phase or two-phase connection re-
quires the mains cable of type H05 BB-F/
H05V2V2-F Tmax 90°C (equal or higher).
The appliance works perfectly on AC 230 V,
AC220V~ or AC240V~ 50Hz electrical net-
work.
You must have the means for disconnection in-
corporated in the fixed wiring. Have the ap-
pliance connected to the mains using a device
that allows the appliance to be disconnected
from the mains at all poles with a contact open-
ing width of at least 3 mm, eg. automatic line
protecting cut-out, earth leakage trips or fuse.
You must have the connection and the con-
necting links carried out as shown in the con-
nection diagram (it is located on the under-
neath surface of the casting of the hob).
8