Inglesina Zippy free Bedienungsanleitung Seite 38

HOOD VENTILATION (FOR THE MODELS WHERE IT IS
FORESEEN)
fig. 33 The hood is equipped with a net fabric insert al-
HOOKING OF THE BLANKET
fig. 34
MAINTENANCE OF THE INTERNAL LINING
fig. 35 It is recommended to remove the internal lining pe-
ADJUSTMENT OF THE BACKREST
fig. 36 To lift the backrest just pull it upwards.
fig. 37 To lower it, act on the lever (C5) positioned under the
HUGGY CAR SEAT
HOOKING OF THE SEAT TO THE FRAME
ceed as follows:
fig. 38 If present, remove the stabilizing supports (T7
ting on the proper push-buttons (T26).
CAUTION: hold the supports during the ejection.
fig. 39 Remove the armrest covers (T3
sing with the index finger the hooking lever (T23) positioned
inside the armrest (T24).
fig. 40
frame on the armrests (T24
mum.
fig. 41 CAUTION: make sure that the seat is always pro-
perly hooked before use.
UNHOOKING OF THE CAR SEAT FROM THE FRAME
fig. 42 Act on the lever (S2) positioned on the rear side of
the seat.
fig. 43
handle.
manual.
TRANSPORT SEAT
HOOKING OF THE TRANSPORT SEAT TO THE FRAME
Before hooking the transport seat to the frame:
fig. 44 If present, remove the stabilizing supports (T7
ting on the proper push-buttons (T26).
CAUTION: hold the supports during the ejection.
fig. 45 Insert the armrest covers (T3) in the proper seats.
CAUTION: when placing the baby, make always sure that
the armrest covers are properly fitted in their seats.
fig. 46 The transport seat is reversible; therefore, it can be
hooked to the frame facing mum or the street.
fig. 47 Hook the transport seat to the frame positioning it in
the proper seats on both sides, following the graphical refe-
rences available on the structure.
fig. 48 CAUTION: make sure that the transport seat is
always properly hooked on both sides before use.
UNHOOKING OF THE TRANSPORT SEAT FROM THE FRAME
fig. 49 Press the lever (R3) and lift one side of the transport
CAUTION: never perform this procedure with baby on
board.
ADJUSTMENT OF THE BACKREST
fig. 50 It is possible to adjust the backrest to 4 positions;
38
All manuals and user guides at all-guides.com
INSTRUCTIONS
act on the central device (R4) and bring the backrest to the
wished position.
USE OF THE HANDRAIL
TRANSPORT SEAT FACING MUM
fig. 51 When the transport seat is facing mum, use the small
handrail (R1) together with its covering.
fig. 52 To hook it, press the levers (R5).
fig. 53 Insert the ends of the handrail in their proper seats
(R6) on the transport seat.
fig. 54 The handrail can be opened on one side or comple-
remove it, repeat the procedure also on the other side.
TRANSPORT SEAT FACING THE STREET
fig. 55 When the transport seat is facing the street, use the
big handrail (T4) together with its covering.
fig. 56 To hook it, insert the ends in the openings on the ar-
- fig. 57 The handrail can be opened on one side or comple-
- under the armrest (T24); to remove it, repeat the procedure
also on the other side.
CAUTION: do not insert the fingers in the openings on the
- armrests when performing these procedures.
HOOD
fig. 58 Insert the ends of the hood in the proper seats on the
sides of the transport seat and hook the buttons to the struc-
ture.
fig. 59
The hood covering can be removed to allow its correct main-
tenance.
fig. 60 Unhook the buttons (R7) positioned on both sides of
the hood articulated joints (R8).
fig. 61 Then, unhook both articulated joints (R8) from the
rods (R9
fig. 62 To reassemble the covering, insert both rods (R9) in
the proper guides on the internal lining.
fig. 63 Then, insert the rods (R9) in the proper seats on both
articulated joints (R8
fig. 64 CAUTION: the curved insertion part of the articu-
lated joints (R8) must always be positioned on the front.
ADJUSTMENT OF THE FOOTREST PLATFORM
- fig. 65 To lower the platform act on both levers (R10) po-
press it downwards.
fig. 66 To lift the platform just pull it upwards: It will block
SAFETY BELTS
fig. 67
position is not correct, extract the belts from the first pair of
lets at the same height.
fig. 68
the ends of the waist one.
fig. 69 Fasten the ends of the waist belt to the central buckle.
fig. 70
rings (R11) and, when being used, it must be adjusted in or-
fig. 71
CAUTION! The inobservance of this precaution may result
in the falling or sliding out of the baby with a resulting
risk of injury.
R5) and extract it; to
T28) present
-