Pre-Operation Check - Honda F506 Bedienungsanleitung

Place the tiller on a firm level surface and hold the tiller level (i.e. with
the tire, stand and drag bar). Stop the engine before starting service of
the tiller. Servicing the tiller on an unstable surface of the ground or
without stopping the engine can cause injury and/or equipment
damage.
Daily inspection and service of tiller is essential for safe and reliable
operation. Perform the following check before operation.
1.Tiller outside
Check for fuel and engine oil leaks.
Make sure that there are no flammable materials (dust, straw, etc.) near
the engine.
2.Control lever function
Check that the lever operates smoothly.
3.Wiring and cables
Check the insulation of each wire and cable for tears and cuts.
Check if there is any wire or cable pinched by the neighboring parts.
4.Engine operation
• Start the engine. Check for abnormal sounds. (See pages 20 and 21
for starting procedure.)
• Check that the engine stops securely by operating the engine switch.
(See pages 30 and 31 for stopping procedure.)
• If you notice any other abnormal symptoms, consult with your
authorized Honda dealer promptly.
5.Bolts and nuts
Check for looseness in fastened parts. Securely tighten all loose parts.

4. PRE-OPERATION CHECK

13