Adding Surface Areas Or Volumes Together - Powerfix Profi 91218 Bedienungs- Und Sicherheitshinweise

All manuals and user guides at all-guides.com
P ress the ON/OFF button
device on.
P ress the MODE button
the symbol „ " for volume measurement, as
well as the designation 0.00m (or 0'00"),
appear in the display
for length measurement flashes. The device
displays in this way, that it is ready for the first
measurement.
A lign the device and press the READ button
If the measurement is successful, the length
will appear at the top of the display. The
symbol for width measurement „
flashes. The device displays in this way, that it
is ready for the measurement of the width.
A lign the device and press the READ button.
If the measurement is successful, the width
will appear at the top of the display. The
symbol for height measurement „
flashes. The device displays in this way, that it
is ready for the measurement of the height.
A lign the device and press the READ button
again. If the measurement is successful, the
height appears at the top of the display, and
at the bottom appears the volume in the m
unit of measurement (or cu.ft = cubic feet).
P ress the MODE button briefly, if a further
volume measurement is required. The figures
in the display are reset, and the device is
ready for a new volume measurement.
Adding surface areas or
volumes together
M easure a surface area or volume as de-
scribed in the section „Measuring surface
14 GB/CY
to switch the
9
repeatedly until
8
. The symbol „ "
10
4
" also
" also
3
.