Napoleon PRESTIGE 665 Bedienungsanleitung Seite 90

Problem
Infrared burner (if Ceramic tiles overloaded with grease
equipped) flashes back drippings and build-up. Ports are clogged.
(during operation the
burner abruptly makes
a loud "whoosh" sound,
followed by a continuous Burner overheated due to inadequate
blow-torch type sound ventilation (too much grill surface covered
and grows dim.) by griddle or pan.)
Cracked ceramic tile.
Leaking gasket surrounding the ceramic tile,
or a weld failure in the burner housing.
Pilot will not light. Lack of gas.
(if equipped)
Obstruction in pilot orifice.
Electrode wire loose or off.
Dirty pilot electrode.
Pilot is actually lit.
Illumination and Side/Rear Electric power is out
burner Ignition do not
work
The grill is not receiving electric power
Ignitor works but the knob The knob lights wire connector disconnected
blue lights don't illuminate from the main wire connector
when turn on the light
switch and the knob red
lights also don't illuminate The light switch doesn't work properly
when turn on the gas
burners The wire harness doesn't work properly
The batteries are low
N415-0524CE-GB-DE May 25.20
Possible Causes Solution
Turn burner off and allow to cool for at least
two minutes. Relight burner and burn on high
for at least five minutes or until the ceramic
tiles are evenly glowing red.
Ensure that no more than 75% of the grill
surface is covered by objects or accessories.
Turn burner off and allow to cool for at least
two minutes, then relight.
allow burner to cool and inspect very closely
for cracks. If any cracks are found, contact
your authorized Napoleon dealer to order a
replacement burner assembly.
Contact your authorized Napoleon dealer for
instructions on ordering a replacement burner
assembly.
After turning pilot knob to high, wait
approximately 20-30 seconds for air to purge
the gas supply line while pressing igniter. Fill
propane cylinder. During initial set-up or after
tank has been refilled, it is best to light one
of the tube burners before lighting the pilot
burner. This enables the gas to reach the
valves on the manifold more quickly.
Clean pilot orifice.
Replace lead wire.
Clean pilot electrode.
The pilot flame, especially on natural gas
units is very difficult to see. Place your hand 1
in. (2.5 cm) above grill surface over the pilot
burner to feel for heat.
Check and replace the batteries in the battery
box if it ran out
Ensure the grill is connected between the
battery box and the control panel connector
Connect the knob light wire connector to the
main wire connector inside of the control
panel
Replace the light switch
Replace the wire harness of the control panel
Replace the batteries
17
EN
www.napoleon.com