Cleaning And Maintenance - Concept VZ1260 Bedienungsanleitung

EN
displayed. Until the appliance reaches the preset temperature, the temperature
blinks on the display.
6. The operating temperature is reached after a couple of seconds.
a) Straightening long hair
Always hold the unit by the grip and at a sufficient distance from the skin and eyes; use a mirror.
- Divide your hair into approximately 4 cm-wide strands.
- Hold the unit in your hand according to Fig. 2.
- Starting from the roots, put the prepared strand between the straightener plates for a moment (see Fig. 2).
- Clamp the straightener plates and pull them slowly from the roots to the tips of the hair (see Fig. 3).
Repeat until your hair is straight.
b) Straightening short hair
The process is the same as for long hair, but instead of pulling the unit along the hair, only press the strands
between the straightener plates for approximately 10 seconds.
7. After the end of the treatment, let your hair cool and then comb it out.
8. Switch the unit off after use by pushing the switch. The display will go out.
9. If you need to put the unit aside during use, always switch it off and put it on a fireproof surface.
10. When using the unit in a bathroom, make sure you switch it off immediately after use, and disconnect it from
the wall outlet, as the proximity of water and any contact of the unit with water are very dangerous, even if the
unit is switched off.

CLEANING AND MAINTENANCE

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as they
may damage the unit's surface!
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
VZ1260
Fig. 2
Fig. 1
Fig. 3
27