Fastening With Corner Adaptor Module Or Pole; Sunshield Mounting - Stahl EC-94 Serie Bedienungsanleitung

6.4.4 Fastening with corner adaptor
module or pole
To install the product on the corner adaptor module
or pole, first of all fasten the support bracket.
Fig. 9
To fasten the support bracket, use the 4 flat washers,
the 4 elastic washers in stainless steel and the 4
hexagonal head screws in stainless steel (A4 class 70)
M10x30mm supplied.
Make sure the thread are free of dirt and debris.
Apply a generous amount of threadlocker (Loctite
270) on the 4 threaded holes on the adaptor module.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
To fix the device to the bracket, consult the relevant
chapter (6.4.3 Bracket mounting, page 97).
16

6.4.5 Sunshield mounting

Remove the protective film before the
sunshield installation (if present).
Fix the sunshield to the housing using the screws and
washers screwed into the upper body of the housing.
Apply a generous amount of thread locking
compound (Loctite 270) into the threaded holes in
the base of the device.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 10
Pay attention to the fixing. Tightening
torque: 2Nm.
MNTCMPXHDC_2038_EN