AKG D 880M Bedienungsanleitung Seite 15

1. To connect the microphone to an unbalanced microphone
input (1/4" jack), use a cable with a female XLR connector
and a 1/4" TS jack plug. These cables are available at music
stores.
Please note that unbalanced cables may pick up interfer-
ence from stray magnetic fields near power or lighting
cables, electric motors, etc. like an antenna. This may cause
hum or similar noise when you use a cable that is longer
than 16 feet (5 m).
2. Plug the female XLR connector on the microphone cable
into the male XLR connector on the microphone.
3. Plug the other connector on the microphone cable into the
desired microphone input jack on your mixer or amplifier.
The optional TM 40 transmitter module allows you to convert
your microphone into a wireless microphone that you can use
with any WMS 40 Series receiver from AKG.
1. Open the fixing screw (1).
2. Pull the XLR connector module (2) out of the microphone
body.
Downloaded from www.Manualslib.com
1
2
manuals search engine
2 Interfacing
2.3 Connecting
the Microphone
to an Unbalanced
Input
Fig. 4: Using an
unbalanced cable.
Refer to fig. 4.
2.4 Optional TM 40
Transmitter
Module
Start by removing
the XLR connec-
tor module:
Fig. 5: Removing
the XLR connector
module.
Refer to fig. 5.
15