Graphic Display; Navigation Buttons; Warning Lights; Menu - DAB MCE/C series Installations- Und Wartungsanleitungen

8.1

Graphic Display

Using the graphic display it will be possible to navigate in an easy and intuitive menu which will enable you to check and modify the
system operating mode, the enabling of the inputs and the working set-point. It will also be possible to view the system status and the
log of any alarms memorised by the system.
8.2

Navigation Buttons

7 buttons are provided for navigating in the menu: 3 buttons under the display, 3 above it and 1 at the side. The buttons under the
display are called active buttons, the buttons above the display are called inactive buttons, and the button at the side is called hidden
button.
Each page of the menu is made in such a way as to indicate the function associated with the 3 active buttons (the ones under the
display).
Pressing the inactive buttons (the ones above the display) produces the effect of inverting the graphics and the buttons that were
active become inactive and vice versa. This function also allows the control panel to be installed "upside down"!
8.3

Warning Lights

Yellow light: System live signal.
If lit, it means that the system is live.
Red light: Warning of an alarm/malfunction present in the system.
If the light is blinking it is a non-blocking alarm and the pump can still be controlled. If the light is fixed it is a blocking
alarm and the pump cannot be controlled.
Green light: Pump ON/OFF signal.
If On, the pump is running. If Off, the pump is stopped.
9.

MENU

MCE/C provides 2 menus: user menu and advanced menu.
The user menu is accessible from the Home Page by briefly pressing the central button "Menu".
The advanced menu is accessible from the Home Page by pressing the central button "Menu" for 5 seconds.
If the menu pages show a key at bottom left it means that it is not possible to change the settings. To unblock the menu go to the
Home Page and press the hidden button and the button under the key at the same time until the key disappears.
If no button is pressed for 60 minutes, the settings are automatically blocked and the display switches off. When any button
is pressed the display lights up again and the "Home Page" appears.
To navigate in the menu, press the central button.
To return to the previous page, hold down the hidden button, then press and release the central button.
To modify the settings use the left and right buttons.
To confirm the change of a setting, hold down the central button "OK" for 3 seconds. Confirmation will be indicated by the following
icon:
ENGLISH
Figure 10: Control Panel
Never remove the cover if the yellow light is lit.
44