Error Codes - Sharp KH-6I31NT00-EU Bedienungsanleitung

N PE
4 5
3 2 1
L3 L2 L1
For the induction hob, the cable must
be H05VV-F 3X4 mm² 60227 IEC 53
••. You will find the connection diagram
shown on the bottom of your appliance.
N PE
4 5
3 2 1
L

ERROR CODES

If there is an error, error code will be
showed at heater displays.
E1 : The cooling Fan is disabled, call
an authorized service agent.
E3 : The power supply voltage is over
the rated values, turn the hob off by
touching
for all zones, turn the hob on by pres-
sing and continue
to use. If same error appears, call an
authorized service agent.
E4 : Supply frequency is different from
the rated values, turn the hob off by
touching
ars for all zones, turn the hob on by
pressing
same error appears, plug off/on turn
the hob on by pressing
to use it. If the same error appears, call
an authorized service agent.
E5 : The hob inside temperature is too
high, turn the hob off by pressing
to let the heaters cool down.
E6 : Communication error between
touch control and heater, call an aut-
horized
service agent.
E7 : The coil temperature sensor is
disabled, call an authorized service
agent.
E8: The cooler temperature sensor is
disabled, call an authorized service
agent.
E9 : Calibration error, call an authori-
zed service agent.
EN 17
,wait until "H" disappears
, wait until "H" disappe-
and continue to use. If
continue