hanseatic HWM6T214D Gebrauchsanleitung Seite 69

Problem
Appliance does not Mains plug is not sitting prop-
work. erly in the socket or is not
plugged in.
Socket has no voltage.
Fuse is not intact.
Wash cycle does No wash cycle set.
not start.
Door is not closed properly.
Cycle was not started.
Appliance is not re- Valve is closed.
ceiving water.
Door is not closed properly.
There is a kink in the water in-
let hose.
The water inlet hose is
clogged.
Filter on inlet is clogged.
Water is not being Outlet hose is clogged or bent. Check outlet hose; dismantle if neces-
pumped.
Lint trap is clogged.
Water is draining Outlet hose is too low.
even though the
appliance is not
pumping.
Water is leaking out Inlet or outlet hose is not
(appliance "leak- screwed on tightly enough.
ing")
Lint trap not closed properly.
Appliance is un- Transport security device(s)
steady or vibrating wasn't/weren't removed.
strongly.
Appliance was not installed or
aligned properly.
The laundry in the drum is
heavy or distributed unevenly.
Spin cycle is not The imbalance correction sys-
running or is slow. tem for imbalanced drum loads
is running.
Malfunction
Possible causes
Troubleshooting table
Solutions, tips
Plug it into the socket properly.
Check fuse; switch on if necessary.
Replace fuse.
Select the desired wash cycle using the
cycle selector (2).
Properly close the door (must hear it
"snap" shut).
Press the "Start/Pause" (9) button.
Open valve.
Close door properly.
Check water inlet hose; dismantle if
necessary and re-align.
Clean the filter on the water inlet hose
(see page EN-23).
Clean the filter on the inlet (see
page EN-23).
sary and re-align.
Clean lint trap (see page EN-23).
Place outlet hose higher.
Screw down inlet or outlet hose down
tighter.
Properly close the lint trap (see
page EN-23).
Remove transport safety device(s).
Install or align appliance properly.
Stop washing and restart to distribute
the laundry more evenly.
No error. Once the laundry is distributed
evenly, the spin cycle starts automati-
cally.
Page EN-31