Spit 352 Bedienungs- Und Wartungsanleitung Seite 14

Instructions for use
Suitable tooling
S2S MAX
tooling
Turbo Kit System
(only for SPIT 352)
Maintenance
Disposal
12
(1) L = 280 mm
(2) Ø 28, Ø 30, Ø 32 mm - useful length = 400 mm
(3) Ø 35, Ø 40, Ø 45, Ø 50, Ø 55, Ø 60, Ø 68, Ø 80 mm
(4) Ø 65, Ø 80, Ø 90, Ø 100, Ø 125 mm
Before using the tool, always take plug out of the socket!
Use only clean and lubricated tools. Change worn dust protection caps (K).
Keep the venting slots clean.
The machine has self-disconnecting carbon brushes. When the
brushes are worn, the motor will switch off automatically. This will be
indicated about 8 hours in advance by the red service light (G). Then a
routine-service is necessary.
Any maintenance or repair work must be carried out in the SPIT after-sales
service or in an after-sales service station formally approved by SPIT.
For queries, please phone one of the numbers listed on the last page of
this booklet.
SPIT will not be responsible for any tools which have been maintained,
repaired or modified by agents not formally approved by SPIT.
We advise you to bring the tool in regular times in service for maintenance
according to the frequency of usage in order to prevent accidents, injuries
or the damage of the tool.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and
electronic equipment and its implementation in accordance with national
law, electric tools that have reached the end of their life must be colle-
cted separately and returned to an environmentally compatible recycling
facility.
Drill bit
14 until 45 mm (only for SPIT 352)
Pick
Chisel
Wide recessing tool
Bent recessing tool
concrete gouge
Brick gouge
Bush-hammer holder and
bush-hammer
S2S Drill bit adapter
(only for SPIT 352)