Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Bosch PKF375N14E Gebrauchsanleitung

Getting to know your appliance

An overview of the models with their dimensions is given on
page 2.

The control panel

Displays
Heat settings
-
‚ Š
Residual heat
/
• œ
Timer
‰‰
Controls
Main switch
%
0 - 9 Settings range
Zone activation
ð
Timer
r

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the size which was last set is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.
If • appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the %
indicator above the main switch lights up. The hob is ready for
use.
To switch off: touch the
%
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
12
Activating and deactivating
Select the hotplate and touch the
symbol. A signal sounds. The
symbol until the indicator above the
Notes
When you touch a symbol, the respective function is
■
activated.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors. The
■
electronics could overheat.
symbol
ð
chocolate. As the hotplate cools down further, the display
changes to œ . The display remains lit until the hotplate has
cooled sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.

Setting a hotplate

Set the required heat setting in the settings range.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting