Noise/Vibration Information - Protool PDP 24-2 EAQ Originalbetriebsanleitung

separately collected and sent for recovery in an
environmental‑friendly manner.
REACh
REACh is a European Chemical Directive
that came into effect in 2007. As "downstream
users" and product manufacturers, we are
aware of our duty to provide our customers
with information. We have set up the following
website to keep you updated with all the latest
news and provide you with information on all
the materials used in our existing products:
http://www.tts‑protool.com/reach
Guarantee
Our equipment is under warranty for at least
12 months with regard to material or production
faults in accordance with national legislation.
In the EU countries, the warranty period for
exclusively private use is 24 months (an invoice
or delivery note is required as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or any
fault acknowledged at the time of purchase, is
not covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before being
sent back to the suppliers or to an authorised
PROTOOL customer support workshop. Store
the operating instructions, safety notes, spare
parts list and proof of purchase in a safe place.
In addition, the manufacturer's current warranty
conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as
a result of ongoing research and development
work.

Noise/vibration information

Levels determined in accordance with EN 60 745
are typically:
PDP 24-2 EAQ:
Drilling
Sound pressure level
Noise level
Uncertainty
Percussion drilling
Sound pressure level
Noise level
Uncertainty
CAUTION
Operating noise
Damage to hearing
► Use ear protection!
Vibration emission value a
three directions) and uncertainty K measured in
accordance with EN 60 745:
Drilling
Percussion drilling
Uncertainty
The emission values specified (vibration, noise)
were measured in accordance with the test
conditions stipulated in EN 60 745 and are
intended for machine comparisons. They are
also used for making preliminary estimates
regarding vibration and noise loads during
operation.
The emission values specified refer to the
main applications for which the power tool is
used. If the electric power tool is used for other
applications, with other tools or is not maintained
sufficiently prior to operation, however, the
vibration and noise load may be higher when the
tool is used.
Take into account any machine idling times
and downtimes to estimate these values more
accurately for a specified time period. This may
significantly reduce the load during the machine
operating period.
L = 80 dB (A)
PA
L = 91 dB (A)
WA
K = 3 dB (A)
L = 101 dB (A)
PA
L = 112 dB (A)
WA
K = 3 dB (A)
(vector sum for
h
a = 2.5 m/s
2
h
a = 13.7 m/s
2
h
K = 1.5 m/s
2
15