Toyotomi FF-V30T Gebrauchsanweisung Seite 11

Press ON/OFF switch to "OFF" position. ON lamp will flash and will go out. Circulation fan and
blower motor continue to run for approx. three (3) minutes to cool down the heater.
NOTE: ON lamp goes out when the fan stops.
NOTE: If ON/OFF switch is pressed during the weekly timer operation mode, the weekly timer
operation mode is canceled.
SECTION F:
ROUTINE MAINTENANCE
CAUTION: Be sure to disconnect heater before performing any checks or cleaning.
CAUTION: Allow heater to cool completely before cleaning or maintenance.
FOR OPTIMUM HEATER PERFORMANCE, THE PARTS SHOWN BELOW SHOULD BE CLEANED REGULARLY:
Louver
1. Clean Louvers (ONCE A WEEK)
Dust and stains should be wiped off louvers with a damp cloth.
2. Clean Circulation Air Filter (ONCE A WEEK)
A mesh filter is located on heater cabinet rear side.
Once a week slide the filter up to remove and it should
be vacuumed clean.
3. Clean Fuel Acceptance Fitting (FF-V30T)
When dirt or dust accumulates in the fuel acceptance fitting, it should be cleaned.
Check fuel acceptance fitting each time your refuel.
TURNING HEATER OFF
Ciraulation air filter Circulation fan
FF-V30T
Louver
Integral fuel strainer (inside)
FF-V30
ENGLISH
Ciraulation air filter Circulation fan
,
10