Cleaning; Safety Instructions For Maintenance; Possible Malfunctions - Bartscher T4 Bedienungsanleitung

6.2 Cleaning

o Clean the device regularly.
o Allow the device to cool down completely.
o Clean the body and the steel spikes with a cloth soaked in water with some
detergent, wipe thoroughly with clean water to remove detergent residues
completely. Afterwards, dry the cleaned surfaces.
o Use only a soft cloth for cleaning, never use coarse cleaners, which can damage the
surface of the device.
o Use a soft, dry cloth to dry and polish the surface after cleaning.

6.3 Safety instructions for maintenance

o Inspect the power cable regularly for damage. Never use the device if the cable is
damaged. If the power cable is damaged, have an authorised service center or
qualified electrician replace it.
o In case of damage or malfunction, please contact your stockist or our customer
service centre. Pay attention to the troubleshooting tips in pt. 7.
o Only a qualified technician and using original spare parts and accessories should
carry out repairs and maintenance of the device. Do not attempt to repair the
device yourself.

7. Possible Malfunctions

Problem
The device is switched on,
but the red power indicator
lamp does not light up.
The ON/OFF switch has
been pressed, the green
heating control lamp does
not light up and the steel
spikes do not get hot.
Cause
• Mains plug not inserted
properly
• Fuse for current supply
has tripped.
• Mains cable is defective.
• Faulty heating elements.
Remedy
• Disconnect the mains
plug and insert it
properly
• Check the fuse, connect
the device to a different
socket.
• Contact a dealer
• Contact a dealer
- 23 -