Cleaning And Maintenance; Environmental Protection; Accessories - Concept VP 4310 Bedienungsanleitung

EN
Cleaning and replacing the permanent filter
This filter can be cleaned by mechanical shaking and cleaning with a soft brush. A heavily fouled filter can be
washed after this step and cleaned with a soft brush in lukewarm water. Do not use detergents.
It is important to let the wet parts dry thoroughly. A wet filter would be damaged if used for
vacuuming! Do not use a hair dryer for drying!
Note: Wet cleaning can cause more wear and tear of the filter, and a correspondingly shorter service life.
• The filter should be cleaned or replaced whenever it is visibly fouled, or when the suction power decreases.
The filter should be checked after each use of the vacuum cleaner.
• Never use the vacuum cleaner without a properly installed filter to avoid damage to the appliance.
• A suitable filter type is available at your local retailer, or it can be ordered from the manufacturer.

CLEANING AND MAINTENANCE

The vacuum cleaner and its accessories can be cleaned with a wet cloth.
Do not immerse the power cord, charging adaptor, or appliance into water or any other liquid.
Do not use aggressive substances for cleaning, such as solvents or abrasives!
TROUBLESHOOTING
Problem
Motor does not run. Depleted accumulator
Dust receptacle full or clogged.
Reduced suction power
Obstructed filter.
Operation time after full Service life of the accumulator is
recharging is less than 1 minute. coming to an end.
Slight heating of the vacuum cleaner is normal and cannot be
Vacuum cleaner heats up
considered a failure.

ACCESSORIES

The following accessories can be bought with the unit:
Motor filter Ord. No. 42391667
Accumulator Ord. No. 42391668
DISPOSING OF THE ACCUMULATOR
The unit contains NiMH accumulator. This accumulator type contains substances that may damage the
environment when decomposing. Before disposal of the unit, or replacing the accumulator, the original
accumulator has to be taken away and brought to a designated collection point.
To rake out the accumulator, open the lower cover.
36
Cause Solution
Charge accumulator
Empty and clean the dust
receptacle.
Clean or replace the filter.
The accumulator must
be replaced. Contact an
authorized service center.
Price: See price list
Price: See price list
VP 4310
SERVICING
Any extensive maintenance or repair requiring access to the inner parts of the product must be performed by
an expert service centre.

ENVIRONMENTAL PROTECTION

• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.
Appliance recycling at the end of its service life:
A symbol on the product or its packaging indicates that this product should not go into
household waste. It must be taken to the collection point of an electric and electronic
equipment recycling facility. By making sure this product is disposed of properly, you will
help prevent the negative effects on the environment and human health that would
otherwise result from inappropriate disposal of this product. You can learn more about
recycling this product from your local authorities, a household waste disposal service or in
the shop where you bought this product.
This product meets all the basic EU regulation requirements that relate to it.
Changes to the text, design and technical specifi cations may occur without prior notice and
we reserve the right to make these changes.
VP 4310
EN
37