Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3-4. Install the Rear Panel on the Wall
Be sure to confirm that the wall is strong enough to suspend the
unit.
(1) Make sure the panel is flush against the wall. Any space
between the wall and unit will cause noise and vibration.
3-5. How to take out Front Grille
Please follow the steps below to take out front grille if necessary
such as when servicing.
(1) Set the vertical airflow direction louvers to the horizontal
position.
(2) Remove the 2 caps on the front grille as shown in the
illustration below, and then remove the 2 mounting screws.
(3) Pull the lower section of the front grille towards you to
remove the front grille.
Front grille
Cap
When reinstalling the front
grille, first set the vertical airflow
direction louver to the horizontal
position and then carry out above
steps (2) - (3) in the reverse order.
Cap
3-6. Indoor Unit Installation
● Do not turn over the unit without its shock absorber during
pull out the piping.
It may cause intake grille damage.
● Use shock absorber during pull out the piping to protect the
intake grille from damage.
Piping
Vane
Fig. 3-6
Vane
(Move the vane
to upward)
Fig. 3-7
Screw
Fig. 3-8
Intake grille
Fig. 3-9
Piping
Shock absorber
(1) For the Right Rear Piping
Step 1
Pull out the Indoor piping
↓
Step 2
Install the Indoor Unit
↓
Step 3
Secure the Indoor Unit
↓
Step 4
Insert the power supply cord and connection
cable
• Insert the cables from bottom of the unit
through the control board hole until terminal
board area.
Right Rear piping
Tape it
with piping in a
position as mentioned
in Fig. below.
Piping
Cover for
Drain hose
the right
Cover for
piping
the bottom
piping
How to keep the cover
In case of the cover is cut, keep the cover at the rear of chassis
as shown in the illustration for future reinstallation.
(Left, right and 2 bottom covers for piping.)
8
Fig. 3-10
Cover for
Cover for the
the left
bottom piping
piping
Fig. 3-11
Cover for piping
Fig. 3-12
Werbung
Inhaltsverzeichnis
