Inserting The Tools - Flex DH5 SDS-Max Originalbetriebsanleitung

DH 5 SDS-max

Inserting the tools

t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
`^rqflk>
rëÉÇ=áåëÉêíáçå=íççäë=ã~ó=ÄÉÅçãÉ=ÜçíK=
tÉ~ê éêçíÉÅíáîÉ=ÖäçîÉë>
 Clean and lightly grease the shaft
of the insertion tool.
 Check dust cap.
– Clean dirty cap.
– Replace defective dust cap.
 Insert insertion tool and turn until it locks.
 Check lock by pulling on the insertion tool.
Removing the tools
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
`^rqflk>
rëÉÇ=áåëÉêíáçå=íççäë=ã~ó=ÄÉÅçãÉ=ÜçíK=
tÉ~ê éêçíÉÅíáîÉ=ÖäçîÉë>
 Pull locking sleeve backwards (1.).
 Remove insertion tool (2.).
Setting the chisel position
The chisel can be adjusted in 12 positions
(moved 30° in each case).
 Pull rotary ring for chisel setting forwards
and hold (1.).
 Turn chisel until the chisel is at the required
angle (2.).
 Release rotary ring for chisel setting (3.).
Switching on the power tool
Without locking the switch:
 Press and hold down the switch.
Switch off the machine:
 Release the switch.
15