Connectors, Jumpers, Slots - MSI K9A Platinum Serie Bedienungsanleitung

4
The fan power connectors support system cooling fan with +12V. The CPU FAN supports Smart FAN function. When
connect the wire to the connectors, always take note that the red wire is the positive and should be connected to the +12V,
the black wire is Ground and should be connected to GND. If the mainboard has a System Hardware Monitor chipset on-
board, you must use a specially designed fan with speed sensor to take advantage of the fan control.
Please refer to the recommended CPU fans at AMD
Fan/heatsink with 3 or 4 pins are both available for CPUFAN.
5
The mainboard provides a standard floppy disk drive connector that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy
disk types.
6
A IDE connector can connect a Master and a Slave drive. You can connect CD-ROM/ Hard Driver and other IDE devices.
The Ultra ATA133 interface boosts data transfer rates between the computer and the hard drive up to 133 megabytes (MB)
per second. The new interface is one-third faster than earlier record-breaking Ultra ATA/100 technology and is backwards
compatible with the existing Ultra ATA interface.
If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. Refer
to the hard disk documentation supplied by hard disk vendors for jumper setting instructions.
7
SATA1.0 connector supports serial ATA data rates of 150 MB/s and will be marked in ORANGE color. SATA 2.0 connector
supports serial ATA data rates of 300 MB/s and will be marked in PURPLE color. Each SATA connector can connect to 1
hard disk device.
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise, data loss may occur during transmission.
En-6
Downloaded from www.Manualslib.com
M S-7280 M ainboard

Connectors, Jumpers, Slots

Fan Power Connectors
Control
SENSOR
+1 2V
GND
CPU FAN
Important
Floppy Disk Drive Connector (FDD connector)
ATA133 Hard Disk Connector (IDE connector)
Important
Serial ATA Connector
Serial ATA cable
Important
manuals search engine
SENSOR or NC
+1 2V
GND
SYS FAN/ NB FAN/
POWER FAN
®
official website or consult the vendors for proper CPU cooling fan.
SATA 1.0 connector (Orange)
SATA 2.0 connector (Purple)
Take out the dust cover and connect
to the hard disk devices
Connect to SATA connector