Battery Installation/Replacement; Outdoor Unit - Mitsubishi Electric PLA-SM EA-Serie Bedienungshandbuch

Packaged air conditioners indoor unit

Inhaltsverzeichnis

Verfügbare Sprachen

2. Parts Names

Notes (Only for wireless remote controller):

■ When using the wireless remote controller, point it towards the receiver on the indoor unit.

■ If the remote controller is operated within approximately 2 minutes after power is supplied to the

indoor unit, the indoor unit may beep twice as the unit is performing the initial automatic check.

■ The indoor unit beeps to confirm that the signal transmitted from the remote controller has been

received. Signals can be received up to approximately 7 meters in a direct line from the indoor

unit in an area 45° to the left and right of the unit. However, illumination such as fluorescent lights

and strong light can affect the ability of the indoor unit to receive signals.

■ If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be inspected.

Consult your dealer for service.

■ Handle the remote controller carefully! Do not drop the remote controller or subject it to strong

shocks. In addition, do not get the remote controller wet or leave it in a location with high humidity.

■ To avoid misplacing the remote controller, install the holder included with the remote controller on

a wall and be sure to always place the remote controller in the holder after use.

■ If the indoor unit beeps 4 times when you are using the wireless remote controller, switch the auto

mode setting to the AUTO (single set point) mode or AUTO (dual set point) mode.

For details, refer to the included Notice (A5 sheet) or the Installation Manual of wireless remote

controller.

■

Outdoor unit

Ref. Pipes

Indoor-Outdoor

Connection wire

Service Panel