Sony KD-49XG7096BAEP Referenz-Anleitung Seite 4

• Install the TV so that the TV's Table-Top Stand does not protrude
out from the TV stand (not supplied). If the Table-Top Stand
protrudes out from the TV stand, it may cause TV set to topple
over, fall down, and cause personal injury or damage to the TV.
• Only qualified service personnel should carry out wall-mount
installations.
• For safety reasons, it is strongly recommended that you use
Sony accessories, including:
 Wall-Mount Bracket: SU-WL450
• Be sure to use the screws supplied with the Wall-Mount Bracket
when attaching the Wall-Mount Bracket to the TV set. The
supplied screws are designed as indicated by illustration when
measured from the attaching surface of the Wall-Mount Bracket.
The diameter and length of the screws differ depending on the
Wall-Mount Bracket model.
Use of screws other than those supplied may result in internal
damage to the TV set or cause it to fall, etc.
8 mm – 12 mm
Transporting
• Before transporting the TV set, disconnect all cables.
• Two or three people are needed to transport a large TV set.
• When transporting the TV set by hand, hold it as shown below.
Do not put stress on the LCD panel and the frame around the
screen.
• When lifting or moving the TV set, hold it firmly from the
bottom.
• When transporting the TV set, do not subject it to jolts or
excessive vibration.
• When transporting the TV set for repairs or when moving, pack
it using the original carton and packing material.
Screw (M6)
Wall-Mount Bracket
TV's rear cover
Topple prevention
KD-65XG70xx / 55XG70xx
8 mm – 12 mm
M6 screw (not supplied)
Cord (not supplied)
Screw (not
supplied)
KD-49XG70xx / 43XG70xx
8 mm – 12 mm
M6 screw (not supplied)
Cord (not supplied)
Screw (not
supplied)
GB
1.5 N·m
{15 kgf·cm}
1.5 N·m
{15 kgf·cm}
3
GB