Troubleshooting - IKEA HYGIENISK Bedienungsanleitung

ENGLISH
5
Turn the mounting
element
counterclockwise
and pull the spray
arm downwards.

Troubleshooting

Warning! Improper repair of the
appliance may pose a danger to
the safety of the user. Any repairs
must be performed by qualified
personnel.
The majority of problems that may occur
can be solved without the need to contact
an Authorised Service Centre.
Problem and alarm code
You cannot activate the appli‐
ance.
The programme does not
start.
6
Wash the spray arm
under running
water. Use a thin
pointed tool, e.g. a
toothpick, to remove
particles of soil from
the holes. Run the
water through the
holes to wash soil
particles away from
the inside.
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance recharges the resin inside the water soften‐
er. The duration of the procedure is approximately 5 mi‐
nutes.
7
Insert the mounting
element in the spray
arm and fix it in the
delivery tube by
turning it clockwise.
Make sure the
mounting element
locks into place.
Refer to the below table for information on
possible problems.
With some problems, the display shows an
alarm code.
Possible cause and solution
8
2
1
Install the cutlery
drawer on the
sliding rails and
block the stoppers.
25