ingenuity Ridgedale Montageanleitung Seite 24

Using the Swing Control Module
Low Battery
Indicator red
Swing Timer
Select Button and
Indicator
Slide the Power Switch to power the swing.
The Speed Selector function provides 5 speed settings and OFF. The LEDs operate sequentially and
in bar graph mode. To start the swing function, press the button until the flashing LED bar graph
displays the desired setting. Then gently push the seat (within 15 seconds) to activate the swing
motion. After five seconds, a single LED will indicate the selected speed. When you change the
speed setting during swing motion, the LED bar graph will flash for five seconds during the speed
adjustment. When the swing timer expires, the swing stops and the Speed Selector and Timer LEDs
turn OFF.
Use the Swing Timer Select function to turn OFF the swing automatically. Press the button to
sequence to the desired timer setting of 30, 45, or 60 minutes. The three LEDs above the button
indicate the selected time period. If you do not select a timer setting (all LEDs are OFF), the unit
uses a default time of 90 minutes for auto-shutoff. To use the swing function after auto-shutoff,
either press the Swing Timer Select Button or the Speed Selector Button.
Press the Nature Sounds/Music Button to begin music and nature sounds playback. Press as needed
to select the desired nature sound or song. Auto-shutoff occurs after about 20 minutes.
Push the Volume Control Switch as needed to turn off or adjust the volume for music and nature sounds.
The Low Battery Detection function detects weak batteries and suspends normal swing operation,
music, and nature sounds. The Low Battery Indicator turns ON (red) when you press a button during
this condition. To restore normal operation, replace all batteries with new alkaline size D batteries.
ENGLISH
Speed Selector
Button and Indicator
Power Switch
– 24 –
Volume Control
Switch
Nature Sounds/
Music Button