SCHUNK LDH Serie Montage- Und Betriebsanleitung Seite 125

Installing the motor
plug
Carefully place the motor plug into the new position.
CAUTION
Be careful with the cable when assembling the motor plug.
•
The cable must not be damaged or subjected to mechanical
•
loads.
The cable must not be crushed when mounting the cable
•
cover.
Observe the correct motor rotation direction!
•
1. Carefully press the motor plug (6) into the notch on the
opposite side.
2. Screw in the 4 screws (5) to fasten the power connector.
3. Lay the cable parallel into the slot.
4. Fit the cover (4) on the opposite side.
5. Screw in the 4 screws (3).
6. Fit the cable cover (2).
7. Screw in the 2 screws (1).
8. Install the motor housing
07.00 | LDH and LDK | Assembly and Operating Manual | en | GAS360923
Maintenance and repair work
Installing the motor housing [ 122] .
}
125