Herunterladen Inhalt Inhalt Diese Seite drucken

Pfannenberg PWI 6302C/ 115 V Betriebsanleitung Seite 43

Luft-/ wasser-wärmetauscher
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
GB
Mounting PWS air/ water heat exchanger (Side mounting)
Switch cabinet assembly
Requirements
-
Cut-out for PWS air/water heat exchanger is created, see figure
(Side mounting).
-
Air/water heat exchanger has been de-energized.
Required tools and material
-
Installation tool
-
Accessory kit: Threaded bolts, screws, nuts, washers
Procedure
 Screw the two threaded bolts provided (accessory pack) into the fastening points (1) of the air/ water heat
exchanger.
 Suspend the unit on the switch cabinet with the threaded bolts (1) installed from outside.
 Screw unit tightly to the inside of the switch cabinet.
 Use the supplied screws, nuts and washers (accessory kit) to fasten the unit.
 Tighten fastening.
The air/ water heat exchanger is attached to the switch cabinet and ready for electrical connection,
see
Electrical connection.
Operating manual PWS and PWI 6302 C 086100048 © Pfannenberg GmbH
1
Mounting 7 - PWS air/ water heat exchanger
1
1
1
Assembly of PWS air/ water heat exchanger
Page 13 / 31

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis