Zanussi ZRB936PXH2 Benutzerinformation Seite 22

• clean the inside and accessories with luke-
warm water and some neutral soap.
• regularly check the door seals and wipe
clean to ensure they are clean and free from
debris.
• rinse and dry thoroughly.
Important! Do not pull, move or damage any
pipes and/or cables inside the cabinet.
Never use detergents, abrasive powders, highly
perfumed cleaning products or wax polishes to
clean the interior as this will damage the
surface and leave a strong odour.
Clean the condenser (black grill) and the com-
pressor at the back of the appliance with a
brush. This operation will improve the perform-
ance of the appliance and save electricity con-
sumption.
Important! Take care of not to damage the
cooling system.
Many proprietary kitchen surface cleaners con-
tain chemicals that can attack/damage the
plastics used in this appliance. For this reason
it is recommended that the outer casing of this
appliance is only cleaned with warm water with
a little washing-up liquid added.
After cleaning, reconnect the equipment to the
mains supply.
Defrosting of the refrigerator
Frost is automatically eliminated from the evap-
orator of the refrigerator compartment every
time the motor compressor stops, during nor-
mal use. The defrost water drains out through a
trough into a special container at the back of
the appliance, over the motor compressor,
where it evaporates.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside.
Use the special cleaner provided, which you
will find already inserted into the drain hole.
22
Defrosting the freezer
A certain amount of frost will always form on
the freezer shelves and around the top com-
partment.
Defrost the freezer when the frost layer reaches
a thickness of about 3-5 mm.
To remove the frost, follow the instructions be-
low:
• pull out the plug from the wall socket or
switch off the appliance
• remove any stored food, wrap it in several
layers of newspaper and put it in a cool place
• remove the freezer drawers
• put insulating material around the drawers,
e.g. blankets or newspapers.
Defrosting can be accelerated by placing bowls
with hot water (not boiling) inside the freezer.
• Loosen the drainage channel from its resting
position, push it in according to the illustra-
tion and place it in the bottom freezer drawer
where water can collect
• carefully scrape off the ice when it starts to
thaw. Use a wood or a plastic scraper
• when all the ice has melted, clean and wipe
the cabinet dry, then put the drainage chan-
nel back in place.
• switch on the cabinet and replace the frozen
foodstuff.
It is recommended to operate the appli-
ance at the highest position of the ther-
www.zanussi.com