Kits Air Nozzle; Start Up - Sagola 4500 xtreme Gebrauchsanleitung

10. Air Nozzle Kits
Air Nozzle Kits LXT TITANIA, LXT AQUA. LXT HVLP and LXT CLEAR.
Nozzle
LXT TITANIA
LXT AQUA
LXT HVLP
LXT CLEAR
11. Start-up
Before each start-up and especially after cleaning or repairing the unit, a check must be made
that all its elements are securely tightened.
If maintenance or repair work is to be carried out, the gun must be depressurised before work
begins (without air pressure). Should this safety measure not be observed, this may lead to
malfunctions, personal injury and accidents, which may prove to be fatal. SAGOLA S.A. does not
accept any responsibility for the consequences of any non-compliance with these safety
regulations.
Open the spray width and product regulators
completely (without removing these from their
housing) by turning these anticlockwise.
Place the pistol on a support so that the axis of the
tank is vertical.
Pour the product to apply into the tank. Until the level is a maximum of 20-25 mm below the
edge of the tank.
Tighten the filler cap firmly. In the version with the
non-drip cap, tip it forward (paint up) or back (paint
down) as necessary.
Connect the gun to the compressed air network.
Adjust the air pressure in the network regulator in order
to compensate for any pressure drop in the network
(estimated at 0.6 bar for each 10 m of hose).
Adjust the air pressure in the air nozzle by operating the flow regulator until the required quality
of finish is obtained (better finishes are not obtained with higher spraying pressures and these
lead to lower performance and worse product transfer).
Position the air nozzle spraying orifices appropria-
tely (when an imaginary line is drawn through the
2 lugs, this must be parallel or perpendicular to
the floor) and perform the required application
test by adjusting the product and spray width
regulators as follows:
Air consumption
320 litres / minute
295 litres / minute
510 litres / minute
365 litres / minute
ENGLISH
Pressure
2 bar
2 bar
2 bar
2 bar