Handling And Operation; Preparation; Charging Of 5 V Devices - Silvercrest SLS 2000 B2 Bedienungsanleitung

Handling and operation

Handling and operation

Preparation

1. Check the maximum input voltage of the device that you want to charge.
This information can be found in the device's operating instructions.
2. Ensure that, when using the connector sockets
power consumption does not amount to more than 1000 mA (about 333 mA
per socket). The USB ports
In this regard, check in the operator manual of the device.
3. Check which adapter cable is required for the device (see the compatibility
table p. 26 - 28).

Charging of 5 V devices

1. Remove the cover from the charging station and then connect the plug of the
appropriate adapter cable into one of the connection sockets
iPod/iPhone/iPad cable
2. Place the cover back on the charging station thereby feeding the adapter
cable through the cut-out on the front panel of the cover.
3. Plug the other end of the adapter cable into the device's power supply socket.
The device now receives its power supply from the charging station. If the device
has a charge control indicator, this will show that the device is charging.
NOTICE
► This charging station is so powerful that all three connection sockets
and the USB ports
total power consumption of connected devices may not exceed 5200 mA
(1000 mA in total for connection sockets
the USB port
► When charging, the iPad or other tablets can be inserted into the retaining
device
SLS 2000 B2
+
4
into one of the USB ports
22
+ can be used simultaneously. However, the
4 5
+ ).
4 5
.
3
- , the maximum total
6 8
can each be loaded with 2100 mA.
5
+
4
- and 2100 mA each for
6 8
- resp. the
6 8
.
5
-
6 8
49
GB
MT