Cameo MULTI FX BAR EZ Bedienungsanleitung Seite 9

SLAVE MODE (SLAV)
Activation of slave mode is as described previously in ACTIVATING STANDALONE MODE. Connect the slave and the master unit (same model)
with a DMX cable (Master = DMX OUT, Slave = DMX IN) and enable one of the standalone modes on the master unit (static mode, automat-
ic-control, sound-control). Now the slave unit will follow the master unit. If there is no control signal, the characters in the display will flash.If
the display shut-off is activated, a small LED dot will flash in the display, The blinking stops when a control signal is present.
DEVICE SETTINGS (SEt)
Press the MODE button several times if necessary to access the highest menu level (Addr/chAn/ModE/SEt/inFo). Use the UP and DOWN
buttons to select the menu item SEt and confirm with ENTER. This will take you to the submenu for setting the following submenu items
(selection with UP and DOWN, change status with UP and DOWN, confirm with ENTER):
SEt (Settings)
Foot Activate/deactivate control via wireless footswitch
invt Mirrored numbering of LED spotlights, derby effects and
strobe lights (1-2-3-4 | 4-3-2-1)
diSP Switches off display after approx. 30 seconds
FAiL DMX operating mode: Operating status in the event of inter-
ruption of the DMX signal
Soun sound control mode: Operating state if no usable audio signal
is present
rESt Reset device to factory settings
DEVICE INFORMATION (inFo)
Press the MODE button several times if necessary to access the highest menu level (Addr/chAn/ModE/SEt/inFo). Use the UP and DOWN
buttons to select the menu item inFo and confirm with ENTER. This will take you to the submenu for reading the following device information
(selection with UP and DOWN, display with ENTER):
inFo
SoFt Display current software version
hour Display operating time in hours
oFF Control is disabled
on Control is activated
oFF Non-mirrored numbering
on Mirrored numbering
oFF Display shutdown disabled
on Display shutdown enabled
hoLd Last command is retained
bLAc Blackout
LASt Last scene will be retained
oFF Blackout
no Do not perform reset
YES Perform reset
V1.xx
xxx.x
9