DeWalt D25102C Handbuch Seite 27

In this mode the tool can also be used as
a lever to free a jammed drill bit.
Bit rotation: non-working position used
only to rotate a flat chisel into the desired
position.
• To select the operating mode, press the safety
lock (5) and rotate the mode selector switch (4)
until it points to the symbol of the required mode.
• Release the safety lock and check that the mode
selector switch is locked in place.
Do not select the operating mode when
the tool is running.
Indexing the chisel position
The chisel can be indexed and locked into 51
different positions.
• Rotate the mode selector switch (4) until it points
to the "bit rotation" position.
• Rotate the chisel in the desired position.
• Set the mode selector switch (4) to the
"hammering only" position.
• Twist the chisel until it locks in position.
Inserting and removing SDS-plus
(fig. C)
This tool uses SDS-plus
inset in fig. B for a cross-section of an SDS-plus
shank).
We recommend to use professional accessories only.
• Clean and grease the bit shank.
• Insert the bit shank into the tool holder (6).
• Push the bit down and turn it slightly until it fits
into the slots.
• Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
• To remove a bit pull back the tool holder locking
sleeve (12) and pull out the bit.
Fitting the side handle (fig. D)
The side handle (10) can be fitted to suit both
RH- and LH-users.
Always use the tool with the side handle
properly assembled.
®
accessories
®
accessories (refer to the
• Loosen the side handle.
• For RH-users, slide the side handle clamp over the
collar behind the tool holder, handle at the left.
• For LH-users, slide the side handle clamp over
the collar behind the tool holder, handle at the
right.
• Rotate the side handle to the desired position
and tighten the handle.
Setting the drilling depth (fig. E)
• Insert the required drill bit as described above.
• Press the depth stop clamp (11) and keep it
depressed.
• Fit the depth adjustment rod (9) through the hole
in the depth stop clamp.
• Adjust the drilling depth as shown.
• Release the depth stop clamp.
Forward/reverse slider (fig. F1 & F2)
D25102(K)/D25102C/D25103K/D25104K (fig. F1)
• Push the forward/reverse slider (3) to the RH-side
for forward (RH) rotation. See arrows on tool.
• Push the forward/reverse slider (3) to the LH-side
for reverse (LH) rotation.
D25203K (fig. F2)
• Push the forward/reverse slider (3) to the LH-side
for forward (RH) rotation. See arrows on tool.
® bit • Push the forward/reverse slider (3) to the RH-side
for reverse (LH) rotation.
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
D25102(K)/D25102C/D25103K/D25203K -
Fitting the chuck adapter & chuck
• Screw the chuck onto the threaded end of the
chuck adapter.
• Insert the connected chuck and adapter in the
tool as though it were a standard SDS-plus
• To remove the chuck, proceed as for removing a
standard SDS-plus
Never use standard chucks in the
hammer drilling mode.
E N G L I S H
®
bit.
®
bit.
27