Dmx-Protocol - EuroLite TC-5 Bedienungsanleitung

Controlling:
After having addressed all TC-5, you may now start operating these via your lighting controller.
Note:
After switching on, the TC-5 will automatically detect whether DMX 512 data is received or not. If the data is
received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights up
permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TC-5.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control channel 1 - Colour-wheel
Linear colour change following the movement of the slider. In this way you can stop the colour-wheel in any
position.
Decimal Hexad. Percentage S/F
0 9 00 09 0% 4%
10 20 0A 14 4% 8%
21 31 15 1F 8% 12%
32 41 20 29 13% 16%
42 52 2A 34 16% 20%
53 63 35 3F 21% 25%
64 73 40 49 25% 29%
74 84 4A 54 29% 33%
85 95 55 5F 33% 37%
96 105 60 69 38% 41%
106 116 6A 74 42% 45%
117 128 75 80 46% 50%
129 190 81 BE 51% 75%
191 193 BF C1 75% 76%
194 223 C2 DF 76% 87%
224 225 E0 E1 88% 88%
226 255 E2 FF 89% 100%
Control channel 2 - Dimmer intensity
Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
All manuals and user guides at all-guides.com
S Closed
S White
S Green
S Red
S Cyan
S Bright green
S Magenta
S Bright blue
S Yellow
S Green
S Deep rose
S Blue
S Scroll
S Sound-controlled
F Forwards rainbow effect with decreasing speed
S No rotation
F Backwards rainbow effect with increasing speed
F Gradual adjustment of the dimmer intensity from 0 to 100 %
25/52
Feature
Feature
51785875_V_1_2.DOC