Dmx-512 Connection / Connection Between Fixtures - EuroLite TC-5 Bedienungsanleitung

Choose the device which is to control the effects. This device then works as master-device, when F6 and F4
or F5 is set to Yes and controls all other slave-devices, which are to be connected to the master-device via a
balanced microphone lead. Connect the DMX OUT-jack with the DMX IN-plug of the next device.
For the slave, set the DMX starting address to A001 and the buttons F4, F5 and F6 to No. You can connect
as many slave-devices as you like.

DMX-512 connection / connection between fixtures

Projector 1
Starting address 1
120 Ohms
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
All manuals and user guides at all-guides.com
Starting address 3
Sensitivity
Power supply
230 V AC/ 50Hz
23/52
Projector 2
Sensitivity
Power supply
230 V AC/ 50Hz
DMX-512 Controller
Projector 3
Starting address 5
Sensitivity
Power supply
230 V AC/ 50Hz
51785875_V_1_2.DOC