Connecting The Gas Cylinder - Burnhard FAT FRED Bedienungsanleitung

CONNECTING THE GAS CYLINDER

Fire and explosion hazard
The following parts are included. They comply with the applicable standard of the country in which the
barbecue is supplied:
• Gas hose (pre-assembled): CE-approved hose line of sufficient length (maximum 1.5 m) that allows
kink-free installation.
• Pressure regulator (pre-assembled on the gas hose): Permanently adjusted and CE-approved pressure
regulator in accordance with DIN EN 16129, max. 1.5 kg/h, operating pressure 50 mbar, suitable for the
gas cylinder used.
1. Twist off the protective cap from the screw connection on the gas grill. Screw the coupling nut on the
end of the hose onto the screw connection on the gas grill. Use a spanner to tighten the coupling nut.
2. Place the gas cylinder in the trolley.
3. Screw the coupling nut of the hose onto the fitting on the pressure regulator and tighten the connec-
tion with a spanner.
4. Screw the coupling nut on the pressure regulator onto the screw connection on the gas cylinder.
Tighten the coupling nut with your hand. To prevent damage to the seal, don't use tools.
PERMITTED GAS CYLINDER SIZES
Gas cylinder sizes that may be operated and stored in the grill base:
5 kg (height 420 mm, diameter 200 mm)
8 kg (height 505 mm, diameter 229 mm)
11 kg (height 600 mm, diameter 300 mm)
45
Diameter