Getting Started - Denver Instrument TP Serie Betriebsanleitung

Getting Started

Storage and Shipping Conditions
– Do not expose the balance to
extreme temperatures, blows,
shocks, vibration or moisture.
Unpacking the Balance
§ After unpacking the balance,
check it immediately for any visible
damage
$ If you see any sign of damage,
proceed as directed in the chapter
entitled "Care and Maintenance,"
under the section on "Safety
Inspection"
$ Save the box and all parts of the
packaging until you have success-
fully installed your balance in case
you need to return it. Before pack-
ing your balance, unplug all con-
nected cables to prevent damage.
Equipment Supplied
– Balance
– Weighing pan
– Pan support (only on models with
a round weighing pan)
– AC adapter, plug type
Additionally supplied with TP-214
models:
– Shield ring
– Shield plate
– Dust cover
Additionally supplied with TP-303,
TP-303 I models:
– Glass draft shield with cover
Installation Instructions
When choosing a location to set
up your balance, observe the
following:
– Avoid placing the balance in close
proximity to a heater or otherwise
exposing the balance to heat or
direct sunlight
– Protect the balance from drafts
that come from open windows or
doors
– Avoid exposing the balance to
extreme vibrations during
weighing
– Do not expose the balance
to extreme moisture over long
periods
Conditioning the Balance
Moisture in the air can condense on
the surfaces of a cold balance when-
ever it is brought into a substantially
warmer place. If you transfer the bal-
ance to a warmer area, make sure to
condition it for about 2 hours at room
temperature, leaving it unplugged
from AC power.
5