Stopping; Using Detergent - Wilks USA TX850 Benutzerhandbuch

TX850

Stopping

OFF
Turn the engine switch to
the off position
Note: make sure you depress the trigger on the gun to fully drain any residual water
left in the system. Failure to do so can result in damage due to corrosion or water
expansion when freezing.

Using detergent

1. Fill a suitable container with pressure washer detergent to mix as necessary. Do not
use washing up liquid as it contains salt.
2. Fit the blue / black nozzle to the end of the lance.
3. Connect the detergent tube to the pump and submerge the other end in the solution
4. Suction and mixing will occur as water flows through the pump.
Note: a thick viscous detergent will not flow freely from
the detergent tank and the residue is likely to cause a
blockage in the system. After using the detergent facility
it should be flushed thoroughly with clean water to
remove any trace of detergent.
8
Turn the fuel tap off by
sliding to the left
© Wilks-USA
English
Turn the water supply off