Storage; Removal From Storage - Wilks USA TX850 Benutzerhandbuch

TX850

Storage

If the washer is not to be used or is to be stored for more than one month the following
storage procedure should be carried out:
1. Drain all the fuel from the fuel tank and the carburettor. Ensure that all fuel has been
removed.
2. Remove the spark plug and pour approximately one table spoon full of clean engine
oil into the spark plug hole.
3. With the ignition turned OFF, gently pull on the recoil starter handle several times.
4. Re-fit the spark plug and continue to pull the recoil starter handle until the piston is
on the compression stroke (when resistance is felt) then stop pulling.
5. Store the pressure washer in a dry well ventilated place under a cover to prevent any
dust or debris from accumulating on the pressure washer.
If the pressure washer is not being used for more than three months or if there is any
danger of ice or frost where the unit is stored, especially during the winter months,
certain precautions must be taken to ensure no damage occurs to your washer or gun.
Follow the previous steps for storage but also ensure there is no water left inside the
unit. The pump may require insulated protection from freezing conditions. The gun
must be drained of fluids to avoid water expansion as this will damage your gun.

Removal from storage

No fuel should have been left in the unit. However if any fuel is present, ensure this
is removed from the tank and carburettor before refuelling with fresh fuel. Check the
deposit cup and empty if necessary.
Note: old fuel will not combust correctly and could damage your engine.
English
© Wilks-USA
13