Location And Function Of Parts And Controls; Front Panel - Sony LMD-1530MD Gebrauchsanweisung

Location and Function of Parts and Controls

Front Panel

qf
a Tally lamp
Turning this lamp on or off can be done with a
PARALLEL REMOTE connector.
For details, see "Pin assignment" (page 52).
b 1 (standby) switch and indicator
Press to turn on the power when this unit is in standby
mode. The indicator turns on. Press again to set the
monitor in standby mode. The indicator goes out.
c - (key inhibit) indicator
Lights when the key inhibit function works.
The indicator blinks when fan error occurs.
For details on the key inhibit, see "KEY INHIBIT menu"
(page 50).
d VOLUME buttons
Press the + button to increase the volume or the – button
to decrease it.
e Menu operation buttons
Displays or sets the on-screen menu.
M/m/</, (arrow) buttons
Select the menu or make various adjustments.
MENU button
Press to display the on-screen menu.
Press again to clear the menu.
RESET button
Resets the value of an item back to the previous value.
This button functions when the menu item is adjusted
(displayed) on the screen.
38
Location and Function of Parts and Controls
1
LINE
qd
1
-
RGB/ EXT BLUE
HDMI COMPONENT SDI SYNC ONLY SCAN ASPECT
RESET
qs qa 0 9 8 7 6
ENTER button
Press to confirm a selected item on the menu.
f ASPECT select button
Press to set the aspect ratio of the picture, 16:9 or 4:3.
g SCAN select button
You can change the scan size of the picture.
Press to change the scan size among over (5% over
scan), normal (0% scan) and full screen set on the SCAN
menu (page 48).
h BLUE ONLY button
Press to eliminate the red and green signals. Only blue
signal is displayed as a monochrome picture on the
screen. This mode is convenient for chroma and phase
adjustments and monitoring of signal noise.
i EXT SYNC (external sync) button
Press to operate the unit on an external sync signal
through the EXT SYNC IN connector.
The EXT SYNC button works when the component/
RGB signals are input.
j SDI button
Press to monitor the signal through the OPTION IN
connector.
k RGB/COMPONENT button
Press to monitor the signal through the RGB/
COMPONENT input connector.
l HDMI button
Press to monitor the signal through the HDMI IN
connector.
MENU
VOLUME 1
-
ENTER
5 4 3 2