Safety Warnings - MELICONI AT49 Gebrauchsanleitung

"AT52" AMPLIFIED INDOOR ANTENNA
The Meliconi AT 49 amplified indoor antenna receives and amplifies digital terrestrial TV
signals and DAB radio signals in the VHF (band III, 174 - 240 MHz) and UHF (470 - 790
MHz) bands.
The antenna may be connected to a television set or a Digital terrestrial decoder.
• Product for indoor use only; do not use outdoors.
• Keep away from water: the device must not be exposed to drips or sprays of water. Do not
use in a damp environment.
• The product must not be exposed to excessive heat, like direct sunlight, fire or similar heat
sources.
• Do not connect the device to any power supply other than the one it was supplied with.
• The power supply unit must be easily accessible to enable the separation of the device from
the electrical mains supply.
• In the event of a fault with the power supply, disconnect it from the electrical mains socket
immediately.
• Do not tamper with, or attempt to repair the device – danger of electric shock.
• The product is not a toy. Keep out of reach of children or domestic animals.
• Disconnect the devices from the electrical mains supply before connecting them together.
A
• Place the antenna in a favourable position, for example, near a window and/or pointing
in the direction of the television transmitter, and at a safe distance from metal objects,
electrical equipment and reinforced concrete walls that could limit reception.
• Using the cable supplied, connect the antenna to the socket on the rear of the television
set or digital terrestrial decoder. If the decoder is fitted with an F-female type antenna
socket, use an F-male plug to IEC-female socket adapter (not included).
• The antenna uses an AC/DC power supply unit (supplied); insert the cable into the
antenna power supply socket and connect the power supply unit to a 230 Vac/50 Hz
mains power socket.
• When using the antenna on a boat or in a camper van, it may be supplied via the DC
12 V 100 mA input socket, taking care to respect the polarity indications marked on the
power supply socket. (adapter not supplied)
• Rotate the know A to switch the antenna on and set the amplification to the maximum.
• Check that the LED on the antenna is illuminated, indicating that the power supply is
correct.
• Switch the device /TV/DECODER) on and select the desired channel.
• Alternatively, in the case of certain decoders or TV sets, the power supply can be
supplied directly via the antenna cable (see the TV/DECODER manual).
AT49
INSTRUCTIONS FOR USE
Thank you for choosing MELICONI.

SAFETY WARNINGS

Installation
(refer to page 2 for connection information)
GB
5