Trouble Shooting; Repairs; Safety Procedures - probst VZ-II Betriebsanleitung

Maintenance and care
6.2

Trouble shooting

ERROR
The clamping-power is not big
enough, the load is slipping out
optional
( )
optional
( )
Adjustment of the gripping range
optional
( )
Property of material
Unbalanced load
Adjustment of the gripping range
optional
( )
6.3

Repairs

Only persons with the appropriate knowledge and ability are allowed to repair the device.
Before the device is used again, it has to be checked by an expert.
6.4

Safety procedures

•
It is the contractor's responsibility to ensure that the device is checked by an expert in periods of
max. 1 year and all recognized errors are removed (→ see DGUV regulation 1-54 and DGUV norm 100-500).
•
The corresponding legal regulations and the regulations of the declaration of conformity must be
observed!
•
The expert inspection can also be done by the manufacturer Probst GmbH.
Contact us at: service@probst-handling.com
•
We recommend affixing the inspection sticker "„Sachkundigenprüfung / Expert inspection" in a clearly
visible place (order no.: 2904.0056+Tüv sticker with year number) after the inspection has been done.
5310.0141
CAUSE
•
The grippers are worn
•
The maximum load is exceed
•
The actual opening width is not
correct
•
The surface of the material is dirty or
the material is not suitable / allowed
for this device.
•
The device is not loaded
symmetrically
•
The adjustment of the gripping
range is not symmetrical.
V3
REPAIR
•
Replace the grippers
•
Reduce the weight of. the load
•
Adjust the gripping range according
to the load you want to transport
•
Check the surface of the material or
ask the manufacturer, if you the
material is allowed for this device.
•
Adjust the position of the load
•
Correct the adjustment of the
gripping range
15 / 16
GB