3.5 Ice-cube production
This appliance is equipped with one or
more trays for the production of ice-
cubes. Fill these trays with water, then
put them in the freezer compartment.
Do not use metallic instruments
to remove the trays from the
freezer.
3.7 Movable shelves
3.8 Positioning the door
shelves
To permit storage of food packages of
various sizes, the door shelves can be
placed at different heights.
3.9 Positioning the sliding box
4. HELPFUL HINTS AND TIPS
4.1 Hints for energy saving
• Do not open the door frequently or
leave it open longer than absolutely
necessary.
3.6 Cold accumulators
One or more cold accumulators are sup-
plied in the freezer; these increase the
length of time for which food will keep in
the event of a power failure or break-
down.
The walls of the refrigerator are equip-
ped with a series of runners so that the
shelves can be positioned as desired.
For better use of space, the front half-
shelves can lie over the rear ones.
The sliding box can be placed at differ-
ent heights.
Do make these adjustments proceed as
follow:
1.
lift the shelf with the sliding box up-
wards and out of the holders in the
door
2.
remove the retaining bracket out of
the guide under the shelf
3.
Reverse the above operation to in-
sert the sliding box at a different
height.
• If the ambient temperature is high and
the Temperature Regulator is set to
low temperature and the appliance is
fully loaded, the compressor may run
continuously, causing frost or ice on
the evaporator. If this happens, set the
Temperature Regulator toward warm-
ENGLISH
27