Common Q & A - SELFSAT -IPD30A Bedienungsanleitung

7. Common Q & A
• No HDMI ports at TV/monitor
– Additional purchase of HDMI to RGB(analog) converter is required to
use the device.
– Converter with external power supply port is recommended for
stable operation.
• Contents is not playing or TV/monitor is flashing or "No signal"
is shown
– Check if the power of the device is properly connected.
– Check the HDMI is properly plugged and TV's external input is
arranged to HDMI.
– Check the status of Wi-Fi at main screen. If signal is weak, get rid of
blockage between Wi-Fi AP and SAT>IP Wi-Fi Dongle and place
them closer.
• Problem with SAT>IP broadcasting reception
– Press red key to check the name and status of connected SAT>IP
server. If desire one is not found,
Restart SAT>IP server
①
or Check the connection of SAT>IP server and Wi-Fi AP
②
or Check the Wi-Fi connection of SAT>IP Wi-Fi Dongle
③
– If there is no issue from the above, go to "Setting" >"Set up system" >
SAT>IP Configuration to default" and then restart.
Wi-Fi AP's name
ENGLISH - 15
Wi-Fi signal
strength