9-Troubleshooting; Information Codes - Haier HW80-B14979 Gebrauchsanleitung

9-Troubleshooting

of a problem please check all shown possibilities and follow below instructions before you
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
improper repairs can cause considerable consequential damages.
A damaged power cable should only be replaced by the manufacturer, its service

9.1 Information codes

Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
1:25
The remaining wash cycle time will be 1 hour and 25 minutes.
6:30
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 minutes.
AUTO
Automatic load detection is working; only in some programmes.
End
Lock-
Door is closed because of high water level, high water temperature or spinning cycle
bEEP OFF
The buzzer is deactivated.
bEEP ON
The buzzer is activated.
The function keys is closed.The programme changing is invalid.
9.2 Troubleshooting with display code
Problem Cause
CLR FLTR
• Drainage error, water is not fully drained
within 6 minutes.
E2
• Lock error.
E4
•
Water level not reached after 12 minutes.
• Drain hose is self-syphoning.
E8
• Water protective level error.
22
Solution
•
• Check drain hose installation.
• Shut the door properly.
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
• Contact the After sales service.
EN
.