Setting Down, Transportation And Storage - Miele S 5211 Gebrauchsanweisung

Pauses during operation (dia. 26)
(for models with radio controls on the
handle)
To pause the vacuum cleaner during
operation:
^ Press the stand-by button - on the
handle.
Warning: The stand-by button is
designed to pause the vacuum
cleaner for short periods of time
whilst vacuuming. After vacuuming,
the vacuum cleaner must be
switched off and unplugged from
the mains electricity supply.
The LED will light up each time a button
is pressed on the handle.
At the end of the pause, you can do
one of the following:
^ Press the stand-by button - again to
switch the vacuum cleaner back on
at the setting you were using before
pausing it.
^ Press the + button to switch the
vacuum cleaner back on using the
highest power setting.
^ Press the - button to switch the
vacuum cleaner back on using the
lowest power setting.
Setting down, transportation
and storage
Parking system for pauses in
vacuuming (dia. 27)
(cannot be used with the SEB 234 L
Electro Premium Electrobrush)
A parking system has been designed
for conveniently parking the suction
tube and floorhead during pauses.
^ Slot the floorhead into the parking
attachment at the back of the
vacuum cleaner.
If the vacuum cleaner is on a
sloping surface, e.g. a ramp, retract
the telescopic tube fully.
Switching on and off with the parking
system
Some models are fitted with an On/Off
switch in the parking system.
The cleaner is automatically switched
off when the floorhead is placed in the
parking attachment. Lifting the
floorhead out of the parking attachment
switches the cleaner back on again.
If your vacuum cleaner is equipped
with + / - foot controls or + / - foot
controls with AutoEco setting, you can
de-activate or activate the parking
system's On/Off function.
^ Switch the vacuum cleaner off with
the On/Off foot control.
^ Press and hold the + and - foot
controls in, and at the same time
switch the vacuum cleaner on with
the On/Off foot control.
en
39