Atag OX6211E Bedienungsanleitung Seite 59

If necessary, it is possible to reverse the
oven door. This operation should be carried
out by authorized personnel ONLY.
Please find the separate instruction.
Customers are recommended not to carry
out this operation themselves. Complaints
as a result of changing the appliance are
excluded from the guarantee.
ATAG supplies a range of cleaning agents
under the name of ATAG Shine.
You may order these on www.hps.nl. This
site also contains several tips on cleaning
and operating the appliance.
Oven shelves and telescopic runners
Before proceeding ensure the oven is
cool and disconnected from the electric-
ity supply.
The shelf supports can be removed for easy cleaning.
Proceed as follows:
1. remove the front screw while keeping the shelf
support in position with the other hand (see
picture).
2. Disengage the rear hook and take off the shelf
support. Do the same thing on the other side of
the oven (see picture).
Cleaning
Clean the set of shelf supports with telescopic rails
on the outside only with commercially available
detergents. Rinse well and dry with a soft cloth.
The telescopic rails must not be cleaned
in the dishwasher.
When cleaning the shelf supports, take care
not to remove the lubricating grease behind
the telescopic runners. This is meant to ensure
their good operation.
3. Once the cleaning is carried out, refit the shelf
supports following the procedure in reverse.
Please, ensure the retaining nuts are secure when
refitting the shelf support.
ATAG 59