Kathrein CAP 200 Kurzanleitung Seite 3

Important points to observe:
•
Follow all the safety instructions listed
in the user manual for HDP 170!
•
Ensure free sight to satellite!
•
Vehicle must be stationary when a satellite is being searched for
(Avoid movement in vehicle)!
•
Before driving away again one must check that the antenna is in
park position!
Search for satellite
1. Switch on the receiver with the mains switch. If the red LED is illuminated (ready for operation), press the stand-by
button on the remote control in order to put the receiver into operation (green LED is illuminated).
2. The screen shows for about 10 seconds:
5. If the satellite signal is not found, the inserti-
on mentioned below will apear. Press the OK
button in order to start the search mode (the
satellite name may vary, depending on the pro-
gramme memory position, e.g. HOTBIRD).
6. If the satellite signal is found, at first only a small
partial picture appears above at right.
Do not stop the search now, since the receiver
undertakes a fine tuning in order to optimize
signal reception!
(This procedure may last up to two minutes depen-
ding on the reception situation)
Note:
The F-button of your remote control unit allows you at almost any time to start a satellite search (Exceptions: You have called up a
menu or a different OSD is already shown). Furthermore, the search will not start if you already have a TV signal. After having pressed
the F-button, the present satellite position is approached; if there is no signal, the OSD for point 5 will appear. Then continue the pro-
cedure as mentioned under point 5.
CAP 200 and 300/HDP 170
Short User guide
No signal!
3. After that, the screen indicates for about 20 sec.:
4. After initialisation, the last satellite position is
approached, the following picture appears:
Signal
7. After this, the following insertion will appear
and after another few seconds the desired TV
programme is shown as full picture: