Let The Fun Begin; Cleaning - Philips GoZero ADD4901BLO/37 Gebrauchsanleitung

2. Remove seal and cap from the CO
bottom. Don't drop the cylinder into the hole. When you feel that it reaches the bottom, begin
screwing the cylinder clockwise until it is fastened. Don't screw too hard since this might break the
threads holding the gas cylinder in place.
3. When you need to replace the gas cylinder, lay the soda maker down on the side and unscrew it
counterclockwise and then carefully pull it out of the compartment.

5 Let the fun begin

1. Fill the carbonating bottle
Rinse the carbonating bottle with cold water before you use it for the first time. Fill the carbonating
bottle with cold, clean water up to the marked filling line.
2. Attach the carbonating bottle
Screw the carbonating bottle into the carbonating bottle socket. Screw counterclockwise if viewed from
above. Don't screw extremely hard - just make sure the carbonating bottle sits properly.
3. Carbonate the water
Press the button downwards firmly until you hear a sound from the valve. The carbonation time is
2-3 seconds for each time.
NOTE:
· NEVER continuously carbonate for over 5 seconds each time. It can lead to gas wastes or personal injury.
· You can add more carbonation to the water by repeating the carbonating process.
4. Ventilate the bottle
When hearing a buzzing sound after 3 seconds, you should release the button back to horizontal
position. Please allow the button release itself. The remaining pressure in the carbonating bottle
will be released with a puff sound. Then the sparkling water is ready. You can unscrew the carbonating
bottle and enjoy it now.

6 Cleaning

Rinse the carbonating bottle
- Rinse the carbonating bottle before the first use.
- Use clean cold water, fiber brush with a mild detergent.
- Do not use solvent, strong detergent cleaner or abrasive cleaners to clean.
NOTE:
· Never wash the plastic carbonating bottles in a dishwasher.
· The full stainless-steel carbonating bottle is dishwasher safe.
cylinder. Carefully insert the cylinder through the hole at the
2
A2-1
A3-3
A3- 4
A3-1
EN 3
A2-2
A3-2